Find or Sell Motorcycles & Scooters in USA

1972 Yamaha Other on 2040-motos

US $6700
YearYear:1972 MileageMileage:9 ColorColor: Silver
Location:

Seattle, Washington, United States

Seattle, Washington, United States
QR code
1972 Yamaha Other, US $6700, image 1

Yamaha Other photos

1972 Yamaha Other, US $6700, image 2 1972 Yamaha Other, US $6700, image 3 1972 Yamaha Other, US $6700, image 4 1972 Yamaha Other, US $6700, image 5 1972 Yamaha Other, US $6700, image 6 1972 Yamaha Other, US $6700, image 7

Yamaha Other tech info

Engine Size (cc)Engine Size (cc):360 TypeType:Dual-Purpose For Sale ByFor Sale By:Private Seller

Yamaha Other description

1972 Yamaha RT2 360 Enduro - Complete frame off restoration 

Purchased from the estate of the original owner and restored to new condition. This bike was last licensed on the street in 1975. I acquired the RT2 and brought it to a master mechanic in Seattle for a complete disassembly and restoration. Tino Martinez at Machina Veloz performed the following procedures during the rebuild:

1) New vehicle inspection
- Vehicle received non-running, all street legal components removed and stored in excellent condition
2) Disassemble entire motorcycle
3) Paint and Bodywork
- Chemically strip frame, fender, tank
- Paint frame, swingarm, triple clamps, and footpeg mounts with DuPont base/clear
- Repair dents in tank, spray tins with epoxy primer, block sand 3 times, 
- Repaint with optically color matched DuPont base
- Apply decals, clear, color sand and buff
4) Engine - Remove and inspect engine top end
- Piston is a Wiseco .025 over in good condition
- Ring end gaps within spec. Replace wrist pin and bearing
- Paint with engine enamel and reassemble
5) Oil pump
- Cleaned and inspected original oil pump, drive gear and seal and reinstalled 
- Replace oil pump hoses, purge system
- Refill with 'smokeless' oil and verify proper operation 
7) Tachometer 
- Install replacement tach drive gear and seal, inspect for proper operation
8) Ignition
- Replace and set points and adjust engine timing
- Replace spark plug wire and cap. Install new spark plug
9) Decompression Valve
- Disassemble, clean and reinstall
10) Engine Side covers
- Remove, sand and polish engine side covers and chain guard
- Hand paint emblems
11) Suspension
- Remove, clean and reassemble forks
- Disassemble shocks. Clean, polish and reassemble rear shocks
- Clean, and lubricate swingarm pivot
12) Tires
- Install new front and rear tires with new tubes and rim strips
13) Wheels
- Hand polish original wheels (rear wheel has scratches)
14) Front Brake
- Replaced damaged front brake pad mounting plate
- Disassemble, clean, recurve and reinstall brake shoes
- Lubricate pivots and cable
- Adjust and check for proper operation
15) Rear Brake
- Disassemble, clean, recurve and reinstall brake shoes
- Sand corrosion from drum inner surface
- Lubricate pivots
- Polish brake pad mounting plate
- Clean and lubricate brake rod
- Adjust and check for proper operation
16) Carburetor
- Disassemble, clean and reassemble carburetor
- Install new fuel filter and hoses
- Adjust idle mixture and speed
17) Petcock
- Disassemble, clean and reassemble petcock
18) Controls
- Disassemble, clean and lubricate throttle assembly and install replacement cable.
- Adjust and lubricate throttle and oil pump cables
19) Handlebar
- replace with period replacement handlebar and replace hand-grips with NOS 
20) Electrical
- New sealed gel battery 6v5a
- Install original stored wiring harness
- Clean turn signal grounds, install turn signals, replace bulbs with new 
- Disassemble, clean and install original rear brake lamp switch
- Disassemble, clean and install original front brake switch
- Disassemble left controls, clean contacts, lubricate pivots and replace damaged wiring on control assembly
- Disassemble ignition. Clean contacts, lubricate and reassemble ignition switch
21) Gauges
- Install stored original tachometer with new cable
- Install new NOS speedometer with new cable
22) Lenses
- Polish and reinstall rear stop and turn signal lenses
- Replace front turn signal lenses with NOS
23 Hardware
- Clean and polish original hardware
- Replace with 8.8 or higher replacement hardware where needed
24) Fuel Tank Filler
- Polish fill cap and lubricate latch mechanism

After restoration and road test, I was required to take my bike to a dealer for safety inspection in order to license it for the road.  The dealer certifies that the systems are operable and meet State standards.  Then I could title it for the street.  In other words, everything including the electrical has been checked once by my mechanic and also by a certified dealer (Seattle Cycle).

This bike starts like it should, rides like it should and looks like it should. Does not leak a drop of oil on my garage floor. 

Has Washington collector plate - never needs tabs again.

I can deliver at no charge this RT2 to a Seattle area shipping location to help the buyer as necessary.

Moto blog

Who To Watch In AMA Pro Superbike This Weekend

Tue, 11 Mar 2014

Photo: Brian J. Nelson Even though reigning AMA Pro Superbike champ Josh Herrin has left the series to try his hand in the Moto2 series, the Superbike field is still filled deep with talent heading into this weekend’s series opening round at Daytona. Here are just a few names to keep an eye on this weekend.

AIMExpo Celebrates Its 300th Vendor

Wed, 14 Aug 2013

With the signing of B&W Trailer Hitches the American International Motorcycle Expo (AIMExpo) has committed 300 exhibitors to its inaugural event this October in Orlando, Fla. “To think that just three weeks ago we were announcing our 250th exhibitor and to now be at a point where 50 more brands have committed to the expo is absolutely remarkable,” says Larry Little, VP and GM of the Marketplace Events Motorcycle Group. B&W Trailer Hitches, an American company, produces a variety of hitches and truck accessories, all aimed at making the process of loading, unloading, and transporting motorcycles as easy and safe as possible.

Yamaha Teases New Star Cruiser to be Unveiled at Daytona Bike Week – Video

Fri, 22 Feb 2013

Yamaha will reveal a new Star cruiser on March 9 during Daytona Bike Week. To promote the upcoming launch, Yamaha released a teaser video revealing a few fleeting glimpses of the new model along with the tag line “less is more”. The video reveals some details such as dual rear shocks, a solo seat and a new single exhaust design.