Indian Chief tech info
Indian Chief description
1952 Indian Chief - Blackhawk - Roadmaster - 80 Chief Now for a little Indian history. When Indian was still in business, even if you were a dealer, if your parts order wasn't over a certain amount, instead of the order going directly to the factory it went to your closest distributor. There was one in California, one in Chicago and one in Philadelphia. Bob, in 1959 or 1960, bought all the old Indian parts, 1953 and earlier, from the Philadelphia East Coast Dealer Distributor, Gene Shillingford and Sons. At that time it was around 50 tons of NOS Indian parts, that's where a lot of the New Old Stock parts came from that we used on this motorcycle. Some of the other NOS parts, like the two fenders, chainguard and gastanks came from the person that purchased all of the parts from the Chicago distributor. The other NOS parts used on this bike that I know of for sure are: Handlebars Handle Grips Shift Lever Luggage Rack Speedo BSC Ignition Switch Dash Light Stoplight Switch Kicker Lever Dimmer Switch Headlight Horn Bracket Front Brake Lever Rear Defender Bumper And of course the two Fenders, Chainguard and Gastanks mentioned above Below are the original Indian parts that were used that weren't NOS but I know dad chose the closest thing to it: Dash Panel Linkert M352 Carb Petcocks Front Fender Tip Rear Bumper Generator, Band and Bracket All Engine Cases Cylinders Heads Transmission Case & Tower Rods Flywheels Horn Rear Safety Bars Brake Drums Brake Panels Wheel Hubs Original Headbolts with the Raised Letter "N" on them Primary Covers-Inner and Outer Fork Top Covers Front Fork Assemblies Rear Shock Assemblies Roadmaster Emblem on Fork Shield Aztec Indian Emblem on Fork Shield Spotlight Brackets Seat T Seatpost Assembly Chummy Seat Helper Spring Assembly Chummy Seat Spring Bracket and U Bolts (attached to motorcycle) Chummy Seat Pan Five Piece Seat Rail Assembly There's definitely more, this is what I know of for sure. It's been quite a long time since we restored this one. The main reproduction parts that were used on this motorcycle are rubber parts and decals. It also comes with a white Indian Chummy Seat, the special ordered earlier type seat pan, just like this bike came with the seatpost and seat bracket, rather than the normal bench type chummy seat that was standard. 52 and 53 Chiefs could be ordered with a solo seat or the earlier style chummy seat and they normally came with right hand throttle and left hand shift. This one was ordered with the left hand throttle, right hand shift. Right now the bike has 24,330 miles on it since the restoration. 20 of those I just put on in the last couple weeks and there's probably going to be a few more until it gets purchased! I know there was at least one top end job done on it so there isn't that many miles on the top end. Everything works and runs good and it's a STRONG runner. It does have a few little nicks and dings here and there in the paint, you can see some wear on certain parts like the saddle bag and seat. Dad rode the bike, he used the bike, it was not a trailer queen, it was used the way it was intended to be used, it was rode. So this isn't one of those "zero mile since restoration" motorcycles. And as you can see it still looks very presentable. On July 24, I took this bike back to Springfield, Massachusetts for Indian Day. I rode it up State Street to the factory for a few pics. And it won "Best Chief" this year at Indian Day. There are a few more pics on our website - bobsindiansales.com |
Indian Chief for Sale
- 1952 indian chief(US $68000)
- 1940 indian chief(US $45,000.00)
- 2003 indian chief(US $8,500.00)
- 1939 indian chief(US $9000)
- 1946 indian chief(US $28,000.00)
- 1999 indian chief(US $29000)
Moto blog
Polaris Reports Increased Results for Both Fourth Quarter and Full Year
Wed, 30 Jan 2013For the 2012 year ending December 31, 2012, Polaris Industries, Inc., (NYSE: PII) reported record net income of $4.40 per diluted share, a 38% increase compared to $3.20 per diluted share. For the fourth quarter of 2012 Polaris reported a net income of $1.24 per diluted share, up 38 percent from the prior year’s fourth quarter net income of $0.90 per diluted share. Reported net income for the full year was $312.3 million, up 37 percent from the previous year’s net income of $227.6 million.
Hero MotoCorp Launches 125cc Ignitor in India
Tue, 03 Jul 2012Hero MotoCorp has launched the Ignitor, a 125cc premium model based on the CBF Stunner from former partner turned rival Honda. The Ignitor is one of the final models Hero will produce with technology licensed from Honda, and it is expected to bridge the gap before Hero introduces its own new models (with help from a gentleman named Erik Buell.) Like the Stunner, the Hero Ignitor is powered by a 125cc single-cylinder engine. Both models claim 11hp and 8 ft-lb., but the Ignitor reaches its peak torque at 5000 rpm while the Stunner has to spin up to 6500 rpm.
2015 Hero Hastur 620cc Streetfighter Concept Revealed – Video
Wed, 05 Feb 2014Hero Motocorp has revealed a new 620cc streetfighter concept called the Hastur at the 2014 Indian Auto Expo in Greater Noida, near New Delhi. The Hero Hastur concept was developed with the help of Erik Buell Racing which provided its expertise in working with larger engines than Hero’s usual small-displacement motorcycles. The Hastur is powered by a parallel twin 620cc engine claiming 78.9 hp at 8000 rpm and 53.1 ft-lb.
Indian Chief by State
| Indian Chief by City
| Indian Chief by Color
|